MDR 10

The mdr 10 has been designed to grind 45° and 90° cutting and bevel disks, for an acceptable wear and better performance of the disk.
As regards cutting disks, the required quantity can be simultaneously modified in order to install them on the gasket of the cutting machine, thus obtaining a perfectly equal diameter of the tool. As far as bevel disks are concerned, a rotation of the diamond tool with respect to the grinding wheel takes place, and the exact position is indicated on a graduated scale. The rotation engine for the tool to be corrected is placed on an orthogonal two-axe board.

technical datas
Power
3.2 kw
Weight
170 kg
Length
800 mm
Height
1700 mm
Width
1100 mm
Water consumption
15 lt/min
Pressure
3-4 bar
back